Rocking Loveseat Bench Glider
PART LIST FIGURE QUANTITY DESCRIPTION A 1 PC RIGHT ARM B 1 PC LEFT ARM C 1 PC BACK D 1 PC SEAT E 1 PC BASE F 2 PCS GLIDER G 6PCS SHORT BOLT ( M6*18 ) H 2PCS LONG BOLT ( M6*40 ) I 8PCS MEDIUM BOLT (M6*30 ) J 8 PCS FLAT WASHER K 16 PCS FLAT WASHER L 1 PC ALLEN WRENCH M 1 PC SEAT CUSHION N 2 PCS BACK CUSHION Page 1/4
Extra Parts PART LIST FIGURE QUANTITY DESCRIPTION G 1 PCS SHORT BOLT ( M6*18 ) H 1 PCS LONG BOLT ( M6*40 ) I 1 PCS MEDIUM BOLT (M6*30 ) J 1 PCS FLAT WASHER K 1 PCS FLAT WASHER Page 2/4
STEP 1 A. PLACE RIGHT ARM (A) UPSIDE DOWN ON A FLAT, PROTECTED SURFACE. B. ATTACH SEAT (D) TO RIGHT ARM (A) WITH FLAT WASHER (K) AND SHORT BOLT (G) USING ALLEN WRENCH (L). DO NOT TIGHTEN COMPLETELY. C. ATTACH LEFT ARM (B) TO SEAT (D) WITH FLAT WASHER (K) AND SHORT BOLT (G) USING ALLEN WRENCH (L). DO NOT TIGHTEN COMPLETELY. STEP 2 A. TURN SEAT ASSEMBLY TO UPRIGHT POSITION. B. CONNECT BACK (C) TO RIGHT ARM (A) AND LEFT ARM (B) WITH FLAT WASHER (K) AND LONG BOLT (H) USING ALLEN WRENCH (L).
STEP 4 A. ATTACH BASE (E) TO SHORT ARM OF GLIDER SUPPORT ON GLIDER (F) WITH FLAT WASHER (K), FLAT WASHER (J) AND MEDIUM BOLT (I) USING ALLEN WRENCH (L). STEP 5 A. TURN GLIDER TO UPRIGHT POSITION SO THAT IT STANDS SQUARELY ON THE FLOOR. B. TIGHTEN ALL BOLTS SECURELY USING ALLEN WRENCH (L). C. RETAIN ALLEN WRENCH (L) FOR USE TO TIGHTEN BOLTS PERIODICALLY OR AS NEEDED. STEP 6 A. PUT SEAT CUSHION (N) WITH BANDAGE TIES ON THE SEAT, THEN PUT ON THE BACK CUSHIONS.
