Warranty

- 13 -
J) Insert the two hopper support rods into the brace holes in the upper and lower rear hopper
tubes (part 15). The hopper assembly is now complete.
STEP 9: Attach Hopper Bag to Sweeper
A) There are two holes in the bar of each of the upper hopper side tubes. Locate the lower hole
and pierce the nylon fabric at the location of the lower hole. Note: some models have rivets
in the fabric and do not require piercing the fabric.
B) Insert the front support rod through the top hole in each of the upper hopper side tubes and
assemble bag arm tube. Secure with R Pin Ø3 (N). Note the orientation of the bag arm tube:
cap upward, male end facing down.