Warranty

- 17 -
BRUSH REPLACEMENT
1. Remove the hopper bag from lawn sweeper.
2. Only replace one brush at a time.
3. Tip the sweeper forward on housing. Do not remove the hex bolts from double brush retainers.
4. Loosen hex bolts and hex lock nuts from single brush retainers. Slide brush out of retainers,
making note of over-lap bristles position.
5. Install new brush, make sure the over-lap bristles are in the same position as before replacement.
IMPORTANT:
If a part needs replacement, only use parts that meet the manufacturer’s specifications. Replacement
parts that do not meet specifications may result in a safety hazard and/or poor operation.
WARNING
Empty hopper bag before storage as full or partially full bags may pop/explode.
STORAGE
• Be sure to completely empty and clean the sweeper hopper bag before storage.
• Failure to properly clean the sweeper and hopper may cause deterioration such as rust or
mold.
• Lightly lubricate all sweeper surfaces and moving parts to protect components and prevent
rust.
• Store indoors or in a protected area during severe weather and winter months.
• Sweeper can be stored compactly:
1. Pull the two bag arm tubes (#8) out of hitch tubes (#1 & #2).
2. Remove the two hopper support rods (#10).
3. Don’t allow the brushes to contact the ground during storage to prevent damage.