Owner's manual

Interval Timer
The interval timer button [ ] is used to set the period of time the camera waits
between taking pictures. You can set interval times of 1 minute, 5 minutes,
or 15 minutes between pictures.
To set the current interval time, press and hold the interval timer button [ ]
for two seconds. The current interval time ashes on the screen.
Press the interval timer button [ ] again to change the interval time.
(Interval times of 1 minute, 5 minutes, or 15 minutes.)
When the desired interval time is displayed, press and release the on/o button [ ] to
set it. The interval time will stop ashing on the screen, conrming that it is set.
Picture Counter
The camera can store a maximum of 40 pictures at 640 x 480 pixels.
The LED indicator will ash RED when the memory is full.
You can see the number of pictures currently stored in memory by pressing and
releasing the interval timer button [ ].
The number of images will be displayed on the screen for a few seconds.
Please Note:
The screen will not show the number of pictures currently stored in the
camera when:
1. The camera is connected via USB.
2. The camera is on and the memory is full.
3. The camera is on and the battery is low.
When the memory is full, be sure to download the pictures as soon
as possible to avoid losing them due to loss of battery power.
ID Space
Use a permanent marker to write your pet's name and your phone number here.
Charging Your Camera
Before you use your Pet's Eye View Camera, the internal battery must rst be charged
for at least 2 hours.
To charge (or recharge) the battery, connect the
camera to a computer using the USB cable. Plug the
small end of the USB cable into the USB port on the
bottom of your Pet's Eye View Camera. Plug the large
end into a USB port on your computer.
Your computer must be ON during charge. The LED
indicator will light up RED while the camera is
charging and will light up GREEN when the camera is
fully charged and ready to take pictures.
Recharge camera 1 to 2 hours before each use.
After every use, download pictures to a computer
as soon as possible. You have 5 hours from the moment the LED indicator starts
ashing RED until the battery is completely drained.
Turning Your Pet's Eye View Camera On and O
To turn on, press and hold the on/o button [ ] for two seconds. The LED indicator
will ash GREEN every two seconds while the camera is on and working.
The LED will blink faster when it is about to take a picture.
To turn o, press and hold the on/o button for two seconds. The LED indicator
will go o.
Rechargeable
battery
included
Lithium-ion
100 mAh
AGES 8 AND UP
1538
On/O
button
LED light
Lens
USB port
Interval timer
and picture
counter button
BATTERY SAFETY INFORMATION
Non-replacement batteries, do not dispose of the battery in re or heat.
• Do not use or leave the battery near a heat source such as re or heater.
• Do not strike or throw the battery against hard surface.
• Do not immerse the battery in water, and keep the battery in a cool, dry environment.
When recharging, only use the battery charger specically for that purpose.
• Do not over-discharge the battery.
• Do not connect the battery to an electrical outlet.
• Do not directly solder the battery and pierce the battery with a nail or other sharp object.
• Do not transport or store the battery together with metal objects such as necklaces, hairpins, etc.
• Do not disassemble or alter the battery.
• Charge the battery every six months.
• Battery Disposal - Turn the power switch off on the device, remove battery, cover the battery terminals with
insulation tape or put it in an individual poly-bag before you take to your local recycling center.
Caution: Changes or modications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Screen
ID Space
Clip
Reset
button
USB cable
Computer
Camera
USB cover
AVOID LOSS OF IMAGES
ATTENTION! If the battery is completely drained, all pictures stored in
the camera's memory will be deleted. Download photos immediately.
FOR BEST RESULTS
• Charge camera before each use
• Download photos as soon as possible after every use
• Do not leave camera plugged into USB for more than 48 hours at a time
• Avoid water damage by securely replacing rubber USB cover
IMPORTANT
To avoid losing your pictures, make sure you download your pictures
within 15 hours of a full battery charge, whether your camera is on or o.
USB port
IMPORTANT!
INSERT USB CABLE AS SHOWN
ARROW

Summary of content (2 pages)