User guide

Incredible Fireworks Lightshow Launcher
FIREWORKS LIGHT SHOW
IN MY ROOM
1
2
3
CAUTION: Do not look directly into the
light source.
BATTERY INSTALLATION
Tool required - Small Phillips head screwdriver
1. Using a Phillips head screwdriver, remove the
battery cover as shown.
2. Insert 3 "AA" batteries as indicated in the
battery compartment and replace cover.
Slide power switch to ON position. Rotate
rework selector to set rework image.
After launch sound eect, pull trigger to make
the rework burst.
Pull back and release lower grip to shoot
rework, and wait to hear launch sound eect.
ON/OFF Switch
IMPORTANT: For best rework projection, use
in a completely darkened room and project
onto a white wall or ceiling from a distance of
4 to 5 feet.
5+
2170
MANUFACTURED BY UNCLE MILTON
INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2012 UMI. All rights reserved. ® and TM designate
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
2170-0250-0312
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit unclemilton.com
Batteries not included
Requires 3 x 1.5V AA/LR6 batteries
A A/ L R6
x3
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution: changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy
before being charged.
• Rechargeable batteries are only to be charged
under adult supervision.
• Different types of batteries or new and used batteries
are not to be mixed.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Do not dispose of batteries in re. Battery may
explode or leak.