User Manual

ManualsBrandsUndercover ManualsFor the carFlex

QUICK START INSTALL GUIDE

PAGE 1

For Customer Service or Warranty Issues, Contact UnderCover Directly (866) 900-8800 www.undercoverinfo.com

Install Parts Check List

Attach Side Mounting Rails

A: Flex hard folding

cover

B: Side mounting

rails, left and right

(pre- assembled)

C: Hardware bag &

Drain tubes (2)

Tools Needed:

9/16” wrench or socket

Note: The Flex was designed

from trucks that do not have

plastic bed liners, some

minor trimming may be

required to allow the cover to

t properly.

Attach both side rails

to the truck bed. The

rails are left and right

specic and have

been pre-assembled

for your convenience.

Note: Refer to the

Model Specic Guide

for more specic

instructions on clamp-

ing the rails to the

truck.

Do not over-

tighten the clamp

assembly.

Clamps must

be checked periodically

for tightness.

Refer to Model Specic Guide for

Special Notes Regarding Your Model

Summary of content (4 pages)

PAGE 1
QUICK START INSTALL GUIDE For Customer Service or Warranty Issues, Contact UnderCover Directly (866) 900-8800 www.undercoverinfo.com 1 Install Parts Check List A: Flex hard folding cover B: Side mounting rails, left and right (pre- assembled) C: Hardware bag & Drain tubes (2) Tools Needed: 9/16” wrench or socket Note: The Flex was designed from trucks that do not have plastic bed liners, some minor trimming may be required to allow the cover to fit properly.
PAGE 2
QUICK START INSTALL GUIDE For Customer Service or Warranty Issues, Contact UnderCover Directly (866) 900-8800 www.undercoverinfo.com 3 Install Cover Slide the two front mounting bolts into the track on the underside of the Flex tonneau cover. Place the Flex tonneau onto the mounting rails with the smallest panel towards the cab of the truck and with the front flap covering the bulkhead (front rail of the bed).
PAGE 3
QUICK START INSTALL GUIDE For Customer Service or Warranty Issues, Contact UnderCover Directly (866) 900-8800 www.undercoverinfo.com 5 Fold Cover up to Attach Once the cover is located correctly, fold the cover up to the open position. Pull the release cables on the rear two panels and turn the red handle to the open position to fold up completely. Take care to fold it gently so the position of the cover is not disturbed.
PAGE 4
QUICK START INSTALL GUIDE 1 To open the cover: Lower the tailgate and pull the cable. While pulling on the cable lift the panel up and towards the cab. Repeat this for the next panel. 2 If this is as far as you would like to open the cover, you can secure it in this position. Release the strap from the stowed position by squeezing the tabs. Attach the buckle at the bulkhead, pull the strap to take up the slack and secure the cover.