User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety
- 1 Important safety directions
- 2 Electrical safety
- 3 Mechanical safety
- 4 Explosion safety
- 5 Fire safety
- 6 Electrostatic discharge (ESD)
- 7 Electromagnetic Compatibility (EMC)
- 8 Modality specific safety
- 9 Network safety, security and privacy
- 10 Toxic or hazardous substances and elements
- 11 Equipment label overview
- 3 Using the Base Station
- 4 Using DoseView
- 5 Using the PDM
- 6 Using the Cradle
- 7 Maintenance
- 8 Troubleshooting
- 9 Product disposal
- 10 Technical data
Getting started
Starting the wall mounted Base Station
1 Connect the output connector of the power adaptor to the back of the Base
Station, if needed.
2 Connect the input connector to an AC electrical outlet socket.
This will switch on the Base Station.
First a Philips start up screen will be displayed for a few seconds and after 30
seconds the system is ready to use. The Online View will display a
maximum of 8 PDMs at a time. Only PDMs that are in range of the Base
Station will be displayed.
The Base Station screen is a touch screen. Operate the Base Station by
tapping buttons and graphs on the screen.
PDMs are shown on a first come first serve principle (see “reserved slots menu” in
section “Admin Settings menu” on page 3-12). PDMs that are not shown in the
Online View still measure and store dose data.
• Do not cover the Base Station to prevent excessive temperatures.
• Be careful when moving other equipment in the vicinity of the Base Station.
3.2
3.2.1
N O T E
W A R N I N G S
3.2 Getting started
3-2
Using the Base Station
DoseAware Base Station Package Document version 1.2
P h i l i p s H e a l t h c a r e 9 8 9 6 0 0 2 1 6 6 2 3 0 9 0 0 a 4 4 7 8 0 0 4 5 a 3 a
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60