Product Manual

ungerglobal.com
Installation &
Operating Instructions
12
Operation
1. Periodically inspect the HydroPower system during use. Ensure hoses are
properly attached. Inspect system for leaks and proper fit of top cap assembly.
2. Take care when working to ensure there is enough slack in waterfed wash pole
hose. This hose is connected to the top of the unit and excessive tugging may
cause the system to tip over.
3. Drinking water ows into the system’s lower connection port via tap pressure
and ows upwards through the HydroPower tank. Pure water exits through the
top connection. When plumbing line pressures fall below 40psi, a reduction in
ow rates will be noticeable.
4. The on/off valve can be used to adjust water ow rates coming out of the
waterfed wash pole brush jets. Excessive ow from the brush head jets can
cause water splattering from uncleaned glass back onto previously cleaned
areas, resulting in spotting.
System Specifications
Model HP06T HP12T/HP12C HP24T/HP24C
DI Resin Capacity 1 bag - 6.0l/0.21 cu. ft. 2 bags - 12.0l/0.42 cu. ft. 3 bags - 24l/0.84 cu. ft.
Power Tap Pressure Tap Pressure Tap Pressure
Pump NA NA NA
Working Hose Length 100 ft./30m plus 100 ft./30m plus 100 ft./30m plus
*All values based on 10 ppm as maximum for pure water quality.
Pure Water Production
*
Soft < 100 ppm > 414 gal / 1,570l > 830 gal / 3,140l > 1,680 gal / 6,360l
Medium 100 – 250 ppm 124 gal - 414 gal / 299 gal - 830 gal / 647 gal - 1,680 gal /
470l - 1,570l 1,130l - 3,140l 2,450l - 6,360l
Hard 250 – 400 ppm 69 gal - 124 gal / 177 gal - 299 gal / 394 gal - 647 gal /
260l - 470l 670l - 1,130l 1,490l - 2,450l
Very Hard > 400 ppm < 69 gal / 260l < 177 gal / 670l < 394 gal / 1,490l
Water TDS Reading HP06 HP12 HP24
OUTPUT