Product Manual
ungerglobal.com
Table of Contents
2
Introduction .............................................................................................. 3
Safety Information ................................................................................. 4
General Information .......................................................................... 4-5
Getting to Know your nLite HydroPower
TM
System .................. 6
System Overview ................................................................................7-8
New Machine Setup ............................................................................... 9
System Start Up ....................................................................................10
System Maintenance – Replacing DI Resin ................................11
Operation .................................................................................................12
System Specifications .........................................................................12
Spare Parts .............................................................................................13
Contents under pressure. Can cause severe injury
or death from tank rupture.
When starting system:
• When starting system, water output must be
open when lling.
• Do not exceed pressure of 115 psi (8Bar).
• Check system for cracks.
• Be sure cover is in locked position.
• Keep water output open and hold yellow lever
down to remove trapped air from system.
• For use only with drinking water.
Before servicing system:
• Shut off drinking water supply and open
water output.
• Disconnect water supply and allow tank to drain.
DANGER
!
Spilled resin is a slipping hazard.
Clean up spilled resin immediately.
Resin can cause skin irritation.
Avoid skin contact.
Wash hands thoroughly after use.
Can cause eye irritation.
Avoid eye contact.
Wear safety goggles.
In case of eye contact, immediately ush
eyes thoroughly with clean water.
Consult doctor if symptoms persist.
READ MANUAL BEFORE
USING PRODUCT
STORAGE: Do not store resin
in open or unlabeled containers.
Store in a cool (15°F to 100°F),
dry place.
DISPOSAL: Dispose of in
accordance with applicable
federal, state/provincial, and
local regulations.
All HydroPower models
require the use of mixed
bed ion exchange resin
(commonly referred to as
de-ionizing resin).
This resin will require
replacement and handling.