G1401 Quick Start Guide FCC ID:P46-G1401
Getting Started: Thank you for choosing the 4G MiFi. Note: This User Guide provides the basic operations of the G1401.
General appearance 1. 2. 3. 4. 5. 6. 7. 8. 9. 10.
Display layout and icons: Icon Description Signal status icon Network mode icon Data flow icon Wi-Fi signal and number of access users The number of unread message,maximum is 100 Battery capacity icon, if battery capacity is lower than 25%, this icon is red. Data Statistics, used/total Install SIM Card and Battery 1. Power off the G1401 2. Remove the back cover and battery 3. Insert the SIM card into card slot in the correct position 4.
points are properly aligned with the SIM card slot. 3. Insert the SIM card into the slot until it is fully inserted. NOTES: The SIM card MUST remain in your G1401 when in use. Once the SIM card has been inserted into the G1401, do not remove! Do not bend or scratch your SIM card. Avoid exposing your SIM card to static electricity, water or dirt. Inserting and Charging the Battery 1.
Removing the 4G LTE SIM Card 1. Power off the G1401. Remove the battery cover and take out the battery. 2. Gently remove the SIM card from the SIM card slot Setting up Wi-Fi connection 1. Press and hold the “power” button for 3 seconds until the welcome logo is displayed on the Screen, and Wi-Fi is on. 2. Use your terminal devices to search the wireless network connection with the Wi-Fi’s SSID of “4G-MIFI-2.4G-xxxx ”or “4G-MIFI-5G-xxxx ” and click “Connect”.
and modify configuration permission. Note: The default username is admin; the default password is admin Restore Factory Settings If you are uncertain of which Wi-Fi settings you have configured or changed, you can restore the factory defaults that come with the MiFi to reconfigure the device Wi-Fi setting. 1. Log into Device Management Website to restore to factory default settings. 2. Press and hold “Reset” button for 5 seconds, and G1401 will be activated again and restored to factory settings.
SCREEN. Make sure you have international roaming enabled on your plan. You can contact your service provider before you go overseas to enable roaming. To the Owner Some electronic devices, such as the electronic system of vehicles, are susceptible to electromagnetic interference sent by your device if inadequately shielded. Please consult the manufacturer of your device before using if necessary. • • Operating your device may interfere with medical devices like hearing aids and pacemakers.
recommended. Battery Handling • Do not short-circuit the battery, as this can cause excessive heat and fire. • Do not store battery in hot areas or dispose of it in a fire, as this can cause an explosion. • Do not disassemble or modify the battery. • When not using the battery for a long period, remove it from your device and store it in a cool, dry place. • Never use a damaged or worn-out charger or battery. • Return the worn-out battery to the provider or put it in an approved recycling container.
FCC statements: The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types G1401(FCC ID: P46-G1401) has also been tested against this SAR limit. The exposure standard for wireless mobile hotspots employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.