DHP980 2.4GHz Digital Headphone User Manual Please read before using this headphone.
INTRODUCTION This 2.4GHz Digital Wireless Headphone uses latest digital wireless technology that enables you to enjoy crystal sound stereo music and TV sound anywhere inside your home. Simply connect the transmitter to a desired audio source: DVD player, CD player, TV set, VCR , Hi-Fi system, or iPod. Without complicated wiring and installation, the system enables you to enjoy thrilling, lifelike sound in minutes. FEATURES 1. 2.4GHz Digital UHF Technology 2. 31-Channel Frequency Hopping System 3.
COMPONENT PART LIST Transmitter 1. Power/Signal/Charge LED indicator 2. Charging pins 3. Attenuation select switch 4. RCA Audio In socket 5. Power on/off switch 6.
Headphone Receiver 7. Charging contacts 8. Volume Up(+) 9. Volume Down(-) 10. Direct Line In 11. Power/Signal link LED indicator 12. ON/OFF Control Accessories 13. RCA cable 14. 3.5mm ~ 3.5mm Direct Line-In Cable 15. AC/DC adaptor 16. NiMH AAA size batteries for Headphone (2 pieces) 17. 3.5mm ~ 6.3mm stereo plug INSTALLATION TRANSMITTER 1. Connect the supplied AC/DC power adaptor to an electrical wall outlet. 2. Plug the AC/DC power adaptor in the DC jack located on the rear of the transmitter.
HEADPHONE RECEIVER 1. To install or replace the rechargeable batteries, carefully pull out the ear pad (Left-Hand Side) and take it out. 2. Insert 2 pieces of AAA size rechargeable batteries (supplied in the package) into the battery compartment of headphone cabinet (Left-Hand Side). Make sure the batteries are placed at the right polarity. 3. Restore ear pad to the earphone cabinet after the batteries are inserted.
HEADPHONE RECEIVER 1. Turn on the headphone by pressing the Power button for about 1 second. The LED will light up in RED. The RED LED will be change to GREEN until audio signal link between transmitter and receiver is established. 2. Place the headphone on your head. To obtain the desired sound level, adjust the volume control on the headphone . 3.
6. This headphone can be used as a regular wired headphone by connecting your Audio source to the headphone jack shown below. IMPORTANT 1. Switching Off a) For protection of the transmitter and power saving, the transmitter will be switched to standby (LED will change to BLUE) automatically if there is no audio source signal for approximately 5 minutes. If the audio source signal returns, the transmitter will be automatically switched on (LED will change to AMBER).
FCC NOTICE 5. This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to this equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
