User's Manual

9
TROUBLESHOOTING
NO SOUND
- Ensure that the mains adapter is pushed fully into the power outlet and
that its cable is properly connected to the DC IN 8V connector on the
transmitter.
- Ensure that the receiver headphones On/Off switch is switched to the
On.
- The headphones battery charge level may be too low. Recharge the
batteries or replace them with fully charged batteries.
- Ensure that your TV set, Hi-Fi system or audio component is switched
ON and set to a channel that broadcasts an audio signal.
- Use the receiver headphones volume control to increase the sound level
when use as a cordless headphones.
- The connected audio/video equipment may not be in playback mode.
Start playback on by the equipment.
- The receiver headphones output level is set too low. Adjust the volume to
a suitable level.
DISTORTION
- If distortion appears, press the “Auto Scan” again.
- Use the channel selector to change the transmitter's transmission
frequency. Then you will need to adjust the tuning control on the
headphones.
- The receiver headphones battery charge level may be too low. Recharge
the batteries or replace them with fully charged batteries.
- Ensure that the volume knob setting is correct.
- The headphones may be too far away from the transmitter. Move closer
to it.
- The audio signal input level is too low. Increase the volume level of the
audio source.