User's Manual

6
REMOTE CONTROL UNIT
1. Remove the battery cover at the rear of the remote control unit and insert 2 pieces “AAA” size
batteries (included) into the battery compartment with the correct polarity.
2. Place back the cover and close the battery compartment
Note
You should now be able to place the speakers freely from room to room without disruption. If disruption
should occur (signal breaks up), press the speaker’s “SCAN” auto-tuning button to maximize best
reception.
If you hear interference from other components, switch the channel control of transmitter, and then move
the speakers to other free location. You can re-adjust the tuning control by moving it either channel 1
or, 2 of the transmitter, then pressing “SCAN” auto-tuning button for best reception.
When transmitting / receiving over long distances, the signal from the system will become weaker.
Switching off
1. For protection of the transmitter and power saving, the transmitter will cut off automatically if there
is no/weak operation input signal from audio source for 4 minutes.
In other words, if the signal comes back, the transmitter will work again automatically.