User's Manual

7
2. Press the POWER button to turn off the speaker and the blue POWER LED light will goes off. If
you use the remote control unit to turn off the speakers, the speakers will be at stand-by mode for
5 minutes and the LED will change from blue to yellow. You can switch on the speakers again by
using the remote control unit during stand-by time. If there is no signal from the remote control
unit for 5 minutes, the speakers will automatically power off.
TROUBLE SHOOTING
NO SOUND
- Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on
the transmitter.
- Ensure the speaker is switch ON.
- Speaker’s battery capacity is too low, replace with new batteries or connect the AC
adaptors to the speakers.
- Ensure the TV or audio component is ON.
- The connected audio / video equipment is not playing. Start playing the equipment.
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED
- Press the “SCAN” button on the speakers or remote control unit until matching the
frequency of the transmitter.
- Change the position of the channel selector on the transmitter. You must then press the
SCAN button on the speaker.
- Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of speakers is adjusted properly.
- The speaker is too far from transmitter, move closer.
- The input level of the audio signal is too low. Turn up the volume of the audio source
equipment.