ig LTT TS on purchasing this modern stereo radio frequency loudspeaker set. They are particularly suitable for connecting to computers, CD players and tape decks, anc they can also be connected to TVs or audio systems. We hope you have much pleasure from using them. How they work: The transmitting station is connected to the sound source, such as CD player, tape deck or computer etc. The transmitting station sends the sound in the form of radio waves to the | speakers. These in turn convert them into sound.
Safety information Follow the instructions for the equipment carefully in all respect Danger * Do not use the equipment if it is visibly damaged. *» Connect the power adapter only to a correctly installed socket. * Keep the power cords away from sharp edges or sources of heat (oven rings etc.). Ar rang * the power cords so that they do not constitute a trip hazard. ¢ Do not use the equipment if there is visible damage to the power cords.
Safety information Batteries « Do be sure to use only the recommended types of batteries. Check the contacts on the equipment and the batteries for cleanliness. If necessary, clean them with a damp cloth, then dry them. The batteries must be installed with the correct polarity (+ and « Do not permit children to change batteries unsupervised by an adult. Small batteries must be kept out of reach of children. « Do not mix old and new batteries or different types of batteries (e.g.
Preparation BR oo Before connecting to the power supply, all other connections should be made. Connecting the transmitting station 1. Choose a suitable position for the transmitting station: The position should not be adjacent to a TV, radio, cordless phone, fluorescent lamp or low energy light bulb, since these can cause interference. 2. Fit the flexible plastic sleeve over the cable aerial. 3. Plug the cable aerial (7) into the socket on the transmitting station, making sure it is fully home. 4.
Switching on and checking 1. Turn the speaker (1) VOLUME control (3) anticlockwise, to the minimum setting. 2. Switch on the device that is linked to the transmitting station. [f the transmitting station is connected to an audio output, the volume control of th: audio device should not be changed. If the transmitting station is connected to the headphone socket set the audio device tc Ci normal volume for playing in a room. Most devices disable the speakers when th wi headphone socket is in use.
GR Bi = Frequency range: 88 Hz -7 kHz Faults / Remedies The transmitting station does not switch on + Check that the audio device is set 10 normal volume, ‘Buzzing the speakers buzz and receive no signal, then either the transmitting station is switched off or the speaker is not set for optimal reception, Check that the Status lamp (6) on the Transmitting station (5} is illuminated.