WIRELESS STEREO WOODEN PANEL SPEAKER:SYSTEM $P490 Transmitter: $P491 Receiver: Sprog Owner's Wanna : Please rid before using the equipment
INTRODUCTION Thee@ MHz stereo wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-F and CD/MP3/VCD/DVD player. Without complicated wiring and installation with your Audio/Video equipment and © rear channel amplifier, the system enables you to enjoy thrilling, lifelike sound stereo in minutes. FEATURES 1.
TRANSMITTER SPEAKER RECEIVER Volume ON/OFF Knob Te Normal/Boost Bass ~~ Auto Scan Button OD DC input N Speaker Panel Supporting Stand Battery Door Supporting Stand Power ON indicator (RED)
INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC power adapter to an electrical wall outlet. 3. Plug the AC power adapter in the DC jack located on the rear of the transmitter. 4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, Monitor, VCR, Radii recorder, CDMP3/VCD/DVD players or to headphone/earphone jack with the connector provided.
2. Switch on the speaker by turning up the VOLUME ON/OFF knob towards ON direction. The POWER/STEREO LED will light up. Switch off the speaker by turning down the VOLUME ON/OFF knob towards OFF direction until a “click” sound is heard. OPERATION 1. Tum on the audio source (TV or audio component) to which the transmitter is connected with. The LED on transmitter will light up. 2. Select the channel the transmitter for best performance in your location. 3.
A). Keep a distance of the speaker up to 7 meters apart from transmitter, and then press “SCAN” auto-tuning button for best tuning reception. 7 bates i B) Whenever you find frequency jam, move your channel switch from i one channel to the other channel (there are three channels for selection) on the transmitter, and then press the “SCAN” auto-tuning button again. ¢ hes > 6. The BASS BOOST button can be used to enhance the bass sound depending on your own music GC preferences.
Note You should now be able to place the speakers freely from room to room without disruption. If disruption should occur (signal breaks up), press the speaker's “SCAN” auto-tuning button to maximize best reception. If you hear interference from other components, switch the channel control of transmitter, and then move the speakers to other free location. You can re-adjust the tuning control by moving it either channel the transmitter, then pressing “SCAN” auto-tuning button for best reception.
0 TROUBLE SHOOTING NO SOUND Ensure the AC adapter is fully inserted into the AC outlet and the power connection input on the transmitter. Ensure the speaker is switch ON. Speakers battery capacity is too low, replace with new batteries or connect the AC adapters to the speakers. Ensure the TV or audio component is ON. The connected audio / video equipment is not playing. Start playing the equipment. The volume of speaker is too low, adjust the volume to an appropriate level.
SPECIFICATIONS Transmission Mode © UHF stereo Cartier Frequency Po BOOM N05 902k MH, Operation Voltage + Transmitter, DC 12V 200mA Speaker, 6 X ‘AA’ size Alkaline batteries 0r DC 12V 450mA adapter Frequency Response ~BOME—13K Hr room 13kHe Distortion 1.5% S/N Ratio © 50dB Channel Separation © 304B Operation Distance Up to 50M (Open Area) Warning © Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.