User manual

UNI-T

UT4000 User Manual

Cursor Measurement

Press [CURSOR] to display the measurement cursor and cursor menu, then adjust the

cursor position by turning the multifunction control knob. As shown in the figure below,

[CURSOR] in the control zone is the function key for cursor measurement.

Figure 2-27 Function key for the sampling system (cursor)

There are two cursor measurement modes to choose from the [CURSOR] menu : voltage

and time. When measuring voltage, press [SELECT] on the front panel and the

multifunction control knob to adjust the positions of the two cursors for ΔV measurement.

Likewise, by selecting time, you can measure Δt. The [CURSOR] menu has two other

modes. In the independent mode, you can adjust the positions of the two cursors

independently. In the tracking mode, you press [SELECT] and multifunction control knob

to move two cursors simultaneously.

1. Measuring voltage/time : Cursor 1 or cursor 2 will appear simultaneously. Adjust

their positions on the screen with the multifunction control knob and select which cursor

to adjust with the [SELECT] button. The displayed reading is the voltage or time value

between the two cursors.

2. When the cursor function is enabled, measurement value is automatically displayed

in the top left corner.

Table 2-23

Function Menu Setup Explanatory Note

Type Time

Voltage

Set time as the measurement parameter.

Set voltage as the measurement parameter.

Close the automatic measurement function.

Mode Independent

Tracking

Adjust the difference between two cursors

with the multifunction control knob.

Adjust the difference between two cursors

with the multifunction control knob or fix the

difference and adjust the cursor positions.

Vertical cursor Second

Select time as the measurement parameter.

Select frequency as the measurement

parameter.