Installation guide

[e-mail]
10
Serial Interface Controls
Follow the following steps:
1. Select Serial with the equipment selection knob of the real-time control panel. The
following screen appears:
Press OK.
2. Click the [Equipment ON/OFF] knob to turn it on. When the indicator lights up the
function is ON. When the indicator lights off the function is OFF.
3. Click the [Data Transmission] knob to turn it on. When the indicator lights up the
function is ON. When the indicator lights off the function is OFF.
Note: This process may take several seconds.
4. Click the [Function] knob on the menu bar than select remote control. The
following screen will appear. You can now control the oscilloscope.