Specifications

[e-mail]
8
Making Measurement
Introduction
Chapter 3 explains how to make measurements.
You could turn the Meter off by turning to OFF position or set up the sleep mode from 1-30 minutes.
Please must ensure the Meter is not under sleep mode if you turn the Meter on but without display.
To avoid false readings, which could lead to possible electric shock or personal injury, replace the battery
as soon as the battery indicator “
” appears.
A. Scope Mode
z The LCD top right part display: RUN, HLD, REV
z The LCD top right corner has battery icon
to indicate when the battery is lower than 5V.
z Under scope mode, both reading and waveform will be displayed.
i. Setting up Sleep Mode, Contrast, Beep
Based on the working environment to set up sleep mode, contrast, beep
Press Set button to set the auto power off, display backlight, contrast and beep
Auto off Bk Light Contrast Beep
F1 F2 F3 F4
F1: Set auto power off time
Auto off ▲ 15 ▼ ENTER
F1 F2 F3 F4
The time level is from OFF, 1 to 30 minutes. Press F4 to confirm, save and return. Press functional
button to exit and the setting remains unchanged.
F2: Set the Display Backlight
BK Light ▲ 15 ▼ ENTER
F1 F2 F3 F4
The brightness level from 0 to 31. Press F4 to confirm, save and return. Press functional buttons to exit,
the setting is kept, but will not save. The setting will be lost after power off.
F3: Set the LCD contrast
Contrast ▲ 15 ▼ ENTER
F1 F2 F3 F4
The contrast level from 0 to 31. Press F4 to confirm, save and return. Press functional buttons to exit,
the setting is kept, but will not save. The setting will be lost after power off.
F4: Set the beeps features, it can only be used under resistance, diode and continuity measurement.
Beep ON OFF ENTER
F1 F2 F3 F4
F2 to turn the beep on
F3 to turn the beep off
F4 to confirm , save and return
Press functional buttons to exit, the setting is kept, but will not save. The setting will be lost after power
off.