User's Manual

3. Press MENU button;

4. Press UP or DOWN button to select the day of week and then press MENU to confirm;

5. Press numeric keypad to enter time in 12hour format;

6. Press UP or DOWN button to select AM/PM;

7. Press MENU button to save the setting;

8. Press BACK button to go back to Standby mode.

NOTE: if day/time is not set, the LCD lower row will blink and dual 7segment LED digit will

show “CL”, and no day/time stamp for those message(s) recorded during day/time is not

set. You must input the day/time again if A/C power interruption is occurred.

TAD PIN SETUP (applicable to base unit only)

This TAD allows you to input your desired TAD remote PIN code. This PIN code is used

when call in to operate the TAD from a remote phone.

1. During Standby mode, press MENU button on the base unit;

2. Press DOWN button until “TAD PIN SETUP” option is pointed by the pointer;

3. Press MENU button;

4. Press 3 digits new PIN code (Preset PIN code is 777);

5. Press MENU button to save the setting;

6. Press BACK button to go back to Standby mode.

DELETE VMWI (applicable to base unit only)

This telephone allows you to force the both lines’ VMWI indicator to off (stop blinking only,

not to turn off VMWI feature) if desired.

1. During Standby mode, press MENU button on the base unit;

2. Press DOWN button until “DELETE VMWI” option is pointed by the pointer;

3. Press MENU button to confirm;

4. The screen show “LINE1 & LINE2 VMWI DELETED!” and the VMWI indicators

will stop blinking immediately;

5. Press BACK button to go back to Standby mode.

LOAD DEFAULT

This telephone allows you to restore the phone setup options back to factory default. The

Load Default action will cause Menu Language back to English, both lines’ Ringer Volume

back to Medium, Line1 Ringer Tone back to Tone 1, Line2 Ringer Tone back to Tone 2, both

lines’ Area Code erased, handset ear piece volume back to Vol.2, base speakerphone

volume back to Vol.4, Tone/Pulse mode back to Tone, both lines’ TAD ring count back to

Toll Save, TAD PIN back to 777, both lines’ TAD status back to Answer On.

1. During Standby mode, press MENU button;

2. Press UP button;

3. Press MENU button;

4. Press UP button to select YES;

5. Press MENU button to confirm Load Default;

6. Press BACK button to go back to Standby mode.

TELEPHONE OPERATION

This telephone is having a general display timeout of 60 seconds, information like menu

items, caller ID, phonebook items, caller log, etc. will be displayed for this period, one can

press the BACK button to cancel the display before this timeout.

NOTE: same procedure about call handling is applicable to both handset and base unless

specified.