User's Manual

CALL STATUS DISPLAY
At the LCD lower row, the call duration timer is shown at the left while the volume is shown
at the right, the call status of both lines are displayed at the middle of the lower row.
“L1” indicates line1 is in normal conversation mode;
“L2” indicates line2 is in normal conversation mode;
“H1” indicates line1 is on hold;
“H2” indicates line2 is on hold;
“M1” indicates line1 conversation is in mute mode;
“M2” indicates line2 conversation is in mute mode;
“C1C2” indicates line1 and line2 are connected to 2 lines conference mode;
TO PLACE A CALL
1. To make line1 call, press the L1 button. The call timer starts to count. “L1” is shown
on the LCD to indicate the call status. Base unit L1-IN-USE LED indicator will light
up.
2. Listen for a dial tone and dial the telephone number.
3. When finished with your call, press the L1 button again (or place the handset on the
base/charge cradle to engage auto-standby feature).
TO PLACE ANOTHER CALL DURING A CALL
1. When having a conversation on line1, you may make a call on line2, press the HOLD
button to put line1 call on hold, “H1” is shown on the LCD to indicate the call status.
L1-IN-USE LED indicator will blink to indicate hold status. Press the L2 button to get
line2 dial tone, “H1L2” is shown on the LCD to indicate the call status.
2. Dial the telephone number and make your conversation on line2 while keeping line1
on hold.
3. Now you can switch between lines, press the HOLD button to put line2 on hold, then
press L1 button to back to line1 conversation, “L1H2” is shown on the LCD. (to
switch line, one may press HOLD to put the current line on hold then the opposite line
button to connect to that conversation)
4. When finished with your current call, say line1 is currently connected, press the L1
button to end line1. To end the line2 call, press HOLD or L2 button to back to line2
conversation, then you can press L2 button to end line2.
TO RECEIVE A CALL
1. When line1 rings, press the L1 button to answer the call (or you can pick up the
handset from the base/charge cradle to let auto-answer feature works for you) and
start your conversation. “L1” is shown on the LCD to indicate the call status.
2. To end your conversation, press the L1 button again. The L1-IN-USE LED indicator
will turn off.
NOTE: If you are expecting incoming calls, you will hear the ring tone on handset or base
only if their respective ringer volume setting of that line is NOT set to OFF mode. There is
always fast blinking at the L1-IN-USE/L2-IN-USE LED respectively indicating the ringing.
TO RECEIVE A CALL ON ANOTHER LINE DURING A CALL
1. During line1 conversation, if a line2 call comes in, short beep alert will be heard at
receiver, you may press HOLD button to put line1 call on hold and then press L2
button to answer the line2 call. “H1L2” is shown on the LCD to indicate the call
status.
2. To switch between lines or end your conversation(s), please refer to step 3 and 4 of
“TO PLACE ANOTHER CALL DURING A CALL” section for details respectively.
16