User's Manual

LAST NUMBER REDIAL
1. If you get a busy tone on line1, press L1 button to hang up.
2. Press the L1 button again and listen for a dial tone.
3. Press the REDIAL button. This will automatically redial the last telephone number
you called (Redial can store up to 32 digits).
4. When finished with your call, press the L1 button on handset or place the handset on
the base/charge cradle (or the L1 button again for base unit case). The L1-IN-USE
LED indicator will turn off.
PAGING BETWEEN EXTENSIONS
1. Press INT button on the extension unit.
2. Press digit button 0~8 to input destination extension number (extension 0 is the base
unit, extension 1~8 is the handsets).
3. Destination extension unit beeps, and will show the paging source extension
information like name or extension number. The page signal will last for 2minutes
and then stops.
NOTE: Paging can be done during Standby mode or Call is on hold. But page to a busy
handset will fail.
INTERCOM WITH OTHER EXTENSION
1. Perform the step 1 and 2 of “PAGING BETWEEN EXTENSIONS” section to start
paging. Destination extension unit beeps.
2. If user, on the destination extension, presses the INT button during paging, it will
bring both units into Intercom mode.
3. When finish with the Intercom, press INT button on either source or destination
extension will end the Intercom mode.
RING ON INTERCOM
1. During Intercom mode, if there comes an incoming call on line1, caller ID will display
on the screen (top right corner of the LCD shows the line of call).
2. Short beep alert will be heard.
3. User on either source or destination extension can press the L1 button to end the
Intercom mode and take the call on line1. (If either source or destination extension is
replaced onto cradle, the Intercom mode will be ended and the unit starts ringing)
QUICK TRANSFER CALL TO OTHER EXTENSION
1. During one line is in conversation while another line is on hold, you can quick transfer
any line to other extension by press the INT button followed by destination extension
number and then the target line button (L1 for transfering line1, L2 for transfering
line2)
2. If destination extension user press the corresponding line button, the call will be
transferred to this extension. Otherwise after 30seconds it will ring back the source
handset for 30seconds.
3. During 1extension 2lines conference mode, you can quick transfer both lines
conference to other extension by using step 1 and 2, either L1 or L2 key will result in
transferring the conference call to the destination extension.
TRANSFER CALL AFTER INTERCOM
1. During one line is in conversation while another line is on hold, you can establish
intercom mode by pressing the INT button followed by destination extension number.
Press the INT button on the destination extension to answer the Intercom call and
start the intercom conversation.
2. After the intercom, press the target line button on the source extension (L1 for
transfering line1, L2 for transfering line2) to transfer the target line to this intercom
connected extension.
17