User's Manual

3. During 1extension 2lines conference mode, you establish the intercom with a
destination extension using step 1 and 2, after the intercom, either L1 or L2 key will
result in transferring the conference call to the destination extension.
CONFERENCE WITH TWO LINE
1. During line1 conversation, press the HOLD button to put line1 on hold, then press L2
button to get line2, “H1L2” is shown on the LCD to indicate the call status. Dial your
telephone number on line2, and starts your line2 conversation.
2. Press the HOLD button to put line2 on hold too, “H1H2” is shown on the LCD. Now
both lines are on hold, other than pressing L1 or L2 button to back to desired line
conversation, you may press CONF button to join both lines to conference mode,
“C1C2” is shown on the LCD to indicate the 2lines conference.
3. During 1extension 2lines conference mode, you can press HOLD to put both lines on
hold, then press L1 button to go back to line1 conversation while keeping line2 on
hold; Or you can press L1 button directly to go back to line1 conversation while
dropping line2.
4. During 1extension 2lines conference mode, you can invite one more extension to join
the conference. Press INT button and then the destination extension number, when
the destination extension answers the page then Intercom mode is engaged, you
may press the CONF button on the source extension to engage the 2extensions
2lines conference mode, the extensions information is shown on upper row of the
LCD while the lines’ information is shown on the lower row.
5. During 2extensions 2lines conference mode, any extension can quit the conference
by pressing the L1 or L2 button, the conference then reduced to 1extension 2lines
conference mode.
TWO EXTENSIONS CONFERENCE WITH ONE LINE
1. During a call, you establish the Intercom mode to another extension, while keeping
the call on hold, using the procedure described in “INTERCOM WITH OTHER
EXTENSION” section.
2. During the Intercom mode, you can press the CONF button on the source extension
to join conference the source, destination extension and the line, the extension
information is shown on upper row of the LCD while the line information is shown on
the lower row.
3. Either source or destination extension can quit this conference by pressing
corresponding L1 or L2 button.
4. During 2extensions 1line conference, you can invite one more external line to form
the 2extensions 2lines conference. If you are using line1 in your conference, press
the HOLD button to put line1 on hold and then L2 button to get line2, dial your telephone
number in line2, press the HOLD button to put line2 on hold, and then press CONF
button to form the 2extensions 2lines conference mode.
MIXED MODE DIALING (Temporary Pulse to Tone Dialing)
• If you only have pulse (rotary dialing) service in your area and want to access Tone
services (Phone banking service, etc.), ensure that the signaling mode setting in the
base unit phone setup menu is set to Pulse mode.
• Press the */TONE button once to switch from Pulse to Tone dialing temporarily, Pulse
dialing mode resumes when the call is ended.
PAUSE FUNCTION
• In some cases, such as PBX or long distance service, a pause may be needed in the
dialing sequence. Pressing the PAUSE button inserts a three-second delay between
dialed numbers.
18