User's Manual

4. Press 2 digits numeric buttons to select location (01~30 for handset while 01~20 for
base unit).
5. Screen will back to Standby mode.
NOTE: If you press the FORMAT button to change the display format before saving to
phonebook, the final displayed number on screen will be stored to the phonebook location.
SELECTIVE DELETING IN THE CALLER LIST
1. Press the UP/DOWN button.
2. Press the UP or DOWN button to scroll to the call record you wish to delete.
3. Press DEL button. The LCD display will show “DELETE RECORD?”.
4. To delete the selected call record, press DEL button again to confirm.
5. Screen will show “DELETED!”.
DELETING ALL RECORDS IN THE CALLER LIST
1. Press the UP/DOWN button.
2. Press the UP or DOWN button to scroll to the call record you wish to delete.
3. Press and hold DEL button. The LCD display will show “DELETE ALL?”.
4. To delete all call records, press DEL button again to confirm.
5. Screen will shows “NO RECORD!” if all records are read, or “UNREAD RECORD,
CANNOT DELETE” if some call records are unread.
ANSWERER OPERATION
This is a sophisticated 2 Lines Digital Answerer incorporated in this 2 lines cordless system.
All incoming messages (ICMs), outgoing messages (OGMs) and Memo messages (MEMO)
are stored digitally into non-volatile memory. Messages are accessed instantly and arranged
compactly in this memory. The answerer can store 13 minutes of messages or 59 messages
at most (ICMs, OGMs and MEMOs combined).
SETTING THE DAY/TIME STAMP
You need to set the day/time at every power up of the base unit, otherwise there will be no
day/time stamp announcement for message playback. Please refer to the TAD DAY/TIME
section of the PHONE SETUP OPERATION chapter for setup details.
The base unit LCD day/time row will blink slowly and dual 7 segment LED digit will show
“CL” if user had not completed this setup.
RECORDING YOUR OUTGOING MESSAGES
Before using your Answerer, it is suggested that you record your own Outgoing Message
(OGM) for each line. This is the announcement callers will hear when the system answers
a call on each line.
1. During Standby mode, press and hold the L1-OGM button to record your own line1
OGM, the answerer will prompts “Please record mailbox 1 announcement after the
tone”;
2. Then release the button and start speak to the microphone when a beep tone is
heard. The 7-segment LEDs will show the countdown time of the OGM recording,
29,28,27,...;
3. Press the STOP button when line 1OGM recording is completed. The updated line1
OGM will be played back from the speaker immediately for your approval.
25