User's Manual

4. To record the line2 OGM, repeat from step1 to 3 but using L2-OGM button to start the

line2 OGM recording, the answerer will prompts “Please record mailbox 2

announcement after the tone”.

NOTE: Maximum OGM recording time is 30seconds.

NOTE: To obtain a better sound quality for locally recorded messages, speak directly into

the microphone from a distance of 9 to 12 inches.

CHECKING YOUR OUTGOING MESSAGE

To check and playback your current outgoing messages.

1. During Standby mode, press the L1-OGM button to check the current line1 OGM in

use, or press the L2-OGM button to check the current line2 OGM in use;

2. The current OGM will be played back from the speaker immediately.

RESTORE TO DEFAULT OGM

To restore the current OGM to pre-recorded system announcement.

1. During Standby mode, press the L1-OGM button to play the current line1 custom

OGM;

2. During playback, press the ERASE button to erase the line1 custom OGM thus the

default line1 OGM is restored and played back to you immediately “Hello, Please

leave a message after the tone”.

3. To restore line2 custom OGM back to default, repeat from step1 to 2 but this time use

L2-OGM button to start the line2 OGM playback.

TURNING THE ANSWERER ON/OFF

You may turn the both lines’ aswerer on/off by pressing buttons on base unit, issue command

during line remote mode or handset remote mode. For operations during remote modes,

please refer to remote section for detail operation.

1. During Standby mode, press the L1 ANS ON/OFF button on the base unit to turn on

the line1 answerer, you will hear “Mailbox 1 answer on” from the speaker as indication;

2. Press the L1 ANS ON/OFF button again to turn off the answerer, you will hear “Mailbox

1 answer off” from the speaker as indication.

3. To turn line2 answer on/off, press the L2 ANS ON/OFF button, you will hear “Mailbox

2 answer on” or “Mailbox 2 answer off” from the speaker as indication.

NOTE: Once turned off, the answerer will answer only after the 10

ring, allowing you to

turn the answerer on or listen to the message stored from a remote location.

NOTE: The 2lines answerer cannot answer to incoming calls at the same time. When

speakerphone is in use, the answerer cannot answer to call on another line, and also no

handset can remote access to the answerer during this period.

SETTING THE RING COUNT

During answer on mode, the answerer on both lines will answer the call on each line after the

number of rings set in the ring count option menu by the user. Please refer to the TAD RING

COUNT section of the PHONE SETUP OPERATION chapter for setup details.

If “3” is selected, the answerer will answer the call after 3 rings;

If “5” is selected, the answerer will answer the call after 5 rings;

If “TS” is selected, the answerer will answer the call after 3 rings if there is new message(s)

in the memory or after 5 rings if there is no new message in the memory, this will save

money for making call from a remote location pay phone because you can hang up the call