User's Manual

at the 4

ring in case no new message to listen to.

NOTE: The new message(s) in the memory can be taken from either line1 or line2.

SETTING REMOTE PIN CODE

There is a remote access PIN code, a 3 digits code, which is required for taking remote to

the answerer when calling from remote telephone. This PIN code is set on the base unit.

Please refer to the TAD PIN SETUP section of the PHONE SETUP OPERATION chapter

for setup details. The default PIN code is 777.

RECORDING A MEMO

You can leave a message to your family member(s) by recording a MEMO message locally.

1. During Standby mode, press and hold the MEMO button to record MEMO message,

the answerer will prompts “Please record message after the tone”;

2. Then release the button and start speaking to the microphone when a beep tone is

heard;

3. Press the STOP button when MEMO recording is completed, the message counter

(7-segment LEDs) will be increased by one.

NOTE: The MEMO message(s) is stored in the same message memory as the ICMs, and

is/are played back together with the ICMs during playback mode.

NOTE: The maximum MEMO recording time per message is 2 minutes.

PLAYING OF MESSAGE/MEMO

During Standby mode, press the PLAY button on base unit to start playback the message(s).

The messages means all ICMs from both lines, MEMO messages. If there is new message

in memory, all new messages will be played back during this round. If there is no new

message in memory, all messages will be played back during this round. Oldest message

will be played first.

1. During Standby mode, press the PLAY button on base unit to start playback of the

message(s);

2. To repeat the current message, press the PREV. button on base unit to go the beginning

of the current message; Press the PREV. button quickly again will skip to the previous

message;

3. To skip to next message, press the SKIP button on base unit;

4. To erase the current message, press the ERASE button on the base unit;

5. To erase all old message(s), press and hold the ERASE button on the base unit;

6. To stop the message playback, press the STOP button on base unit.

7. To change volume of playback, press the VOL.UP or VOL.DOWN button to change

the volume to desired level, the 7-segment LEDs shows “L1”, “L2”,... “L8” as

speaker volume indication.

NOTE: TAD local operation is not allowed during base or handset(s) line in use state.

NOTE: TAD local operation could be interrupted by talk on request from handset(s).

HANDSET REMOTE MODE

You can listen to the message and turn answerer on/off using handset by entering the

handset remote mode.