User's Manual

1. During Standby mode, press the REMOTE button on handset to enter the remote
mode, the LCD shows “ANSWERER REMOTE ACCESS MODE”;
2. You can press ‚ to playback the message as operating the base unit;
3. During playback, press • will goes to beginning of current message and quickly
press again will goes to previous message, or press ƒ to goes to next message, or
press € to erase current message;
4. At the beginning of the remote mode or after the stop of message playback, you will
hear the voice menu “For help menu, press 7; To turn mailbox 1 answer off on, press
4; To turn mailbox 2 answer off on, press 6; To playback, press 2; To stop, press 2
again; During playback, to skip to next, press 3; To skip to the previous, press 1; To
delete, press 0”.
5. During remote mode, you can press „ to turn line1 answer on/off and hear the voice
prompt “Mailbox 1 answer on” or “Mailbox 1 answer off” for indication. You can
press † to turn line2 answer on/off and hear the voice prompt “Mailbox 2 answer
on” or “Mailbox 2 answer off” for indication;
6. During remote mode, you can press ‡ to hear the voice menu again.
NOTE: Handset remote TAD operation is not allowed during base line in use state.
NOTE: Handset remote TAD operation could be interrupted by talk on request from base.
LINE REMOTE MODE
You can call to your answerer from a remote tone telephone. Answerer will answer the call
after the preset ring count. (either 3, 5, or 10 rings)
1. When the answerer answering the call, enter your 3 digits PIN code to engage the
line remote mode. If the answerer does not prompts you the voice menu, that mean
some DTMF tone code cannot be correctly received, please re-enter the PIN code
again within 8seconds timeout period, you may need to enter * before the PIN to force
the answerer to start over the reception of PIN code sequence.
2. At the beginning of the remote mode, you will hear the voice menu, same voice menu
as in handset remote mode, please refer to the tone command described in HANDSET
REMOTE MODE section for detail. (you may turn any lines’ answerer on/off, playback
message, erase message)
3. If the answerer cannot receive your next command within 8 seconds timeout counting
from the end of completion of previous command, it will disconnect your call.
4. If you disconnect the call, the answerer will disconnect after 8 seconds.
INCOMING CALL SCREENING
When there comes an incoming call, you can let the answerer take the call for you. On the
other hand you press the REMOTE button on handset to enter call screening mode 3
seconds after the answerer answers the call, screen will show “SCREENING L1” or
“SCREENING L2” for line1 and line2 case respectively, and you can listen to the caller
from the handset receiver while the caller don’t known that the call is being screened.
If you want to talk to the caller directly, press L1 button (or L2 button if for line2) to interrupt
the ICM recording and talk with the caller immediately.
28