User's Manual
34
1. On Handset 1, press key to
answer the
incoming call.
2. On Handset 1, press
PAGE
key and then press “2” on the
keypad to page Handset 2.
(This also places the caller on
HOLD.)
3. On Handset 2, press
key to
answer the page.
4. On Handset 1, press
key
to initiate conferencing. Both
Handset 1 and Handset 2 are
now connected to the outside
caller.
5. On either handset , press
key to end the call and return
to off-line.
75. NON-DISTURB FUNCTION (DO-
NOT-DISTURB)
This function turns off the
handset ringer and allows the
user to ignore all incoming calls
(except
intercom calls).
1. Press and hold
key for ve
seconds to enter non-disturb
function and the screen
displays “NON-DISTURB”.
2. To turn-off “NON-DISTURB”,
press and hold
key again
for ve seconds.
76. PAUSE FUNCTION
During pre-dialing or one-touch
memory programming, press the
key, it will insert a 2-second
pause into the dialing sequence.
77. BARRING (TOLL CALL
RESTRICTION)
This function allows the user to
prevent certain phone number
prex from dialing out. For
example: 1 900 xxx xxxx
numbers can be
restricted.
1. While off-line, press
key
and screen displays “CALL
LOG”.
2. Press
key to scroll to “HS
SETTING”. Press
to
select.
3. Press
key to scroll to
“BARRING”. Press
to
select.
4. Handset screen displays “PIN
?”.
5. Enter PIN on keypad and then
press
to conrm (default
PIN is “0000”). Press
key
to turn it on if necessary.
6. Handset screen displays
“SELECT NUM”. Press
to conrm.
7. Handset screen displays
“NUMBER 1”. Press
to
conrm.
8. Handset screen displays
“NUMBER ?”.
9. Enter the prex for toll
restricting (up to 4-digits is
allowed).