User's Manual

Out-Of-Range Warning Tone
While talking, there will be a long beep sound if the handset is
out-of-range from the base. Please walk back toward the base
immediately to remedy the situation.
Handset and Base Default Setting (Restore Factory Defaults)
Note: This setting restores factory default settings (tone dialing,
ringer volume is set at maximum). All custom settings will be lost.
One-touch memories are not affected.
1. While o ff -line, press and hold key for 3~ 5 seconds
resets to factory defaults. A beep tone confirms the reset.
2. Please wait 5 ~ 30 seconds for the handset to re-establish
handshaking with the base before using. You should hear a
Call Waiting
If you are on a call and there is a new call coming in, you will hear
a short beep tone in your receiver indicating a new call is waiting.
(Note: You must subscribe to Call Waiting service from your local
Answer a new call and place the first call on " "HOLD
1. Press key to answer this new call will automatically
place the first call on HOLD.
2. Press key again t o switch back to the first caller while
placing the second (new) caller on HOLD. This way you can
go back and forth between these two calls.
To end the first call but keep the second (new) call
1. Te ll the other party to hang u p while on the first call.
2. Press key jump s back to the second (new) call.
3. Press key to end the call.
long beep tone as confirmation.
phone company in order to enjoy this convenience.)
Intercom Between Handsets
1. This funct io n is available when two or more handsets are
registered to the same base. The handset that came with
each system is HANDSET 1 (HS 1). Each subsequent
handset added to the system is automatically assigned as
HS 4 and HS 5. Users need to remember the HS 2, HS 3,
2. Base must be powered up in order fo r the intercom function
Intercom from Handset 1 to Handset 2
1. While in the s tandby mode, press key on “ ”Handset 1
to initiate intercom tone.
PAGE
handset in order to use the intercom function number of each
to work.
2. Press "2"on keypad to call. will ring. "Handset 1" "Handset 2"
3. The user on activates "Handset 2" key to ent er intercom
4. Press key on either handset to end the intercom call and
returns to the standby mode.
mode and talk.
Forward an Incoming Call from Handset 1 to Handset 2
1. On Handset 1, press key and then press on the" 2"
Handset 2 (via intercom) while putting keypad. This p ages
2. When Handset 2 rings, press key on to answer
3. Over the int e rcom, tell Handset 2 that an outside call is waiting.
4. Press key on Handset 1 to transfer the call and then press
key on Handset 1 to exit.
(Note: If within 30 seco nds there is no answer, the call will ring
outside call on HOLD. the
the page.
handset 1.)
11 12
properly.