User's Manual

Specification
Amplified dB level (Amplify off): 0 to 18 dB in 5 steps
Conference Call
This allows two handsets conferencing with the incoming caller.
1. On Handset 1, press key to answer the incoming call.
2. On Handset 1, press
p age key and then press "2 on "
the keypad to page Handset 2. (This also places the caller
3. On Handset 2, press
ke y to answer the page.
4. On Handset 1, press key to init iate conferencing.
Both Handset 1 and Handset 2 are now connected to the
5. On either handset , press key to end the call an d return
Pause Function
on HOLD.)
outside caller.
to off-line.
During pre-dialing or one-touch memory programming, press
key insert s a 2-second pause into the dialing sequence. For
example: 9 P 7 2 2 8 8 5 0 where "P" represents a 2-second
pause. This pause is needed to access an outside line on some
Handset Power On / Off
Power down a handset ignores all calls and saves battery power.
1. Press and h o ld
key for five seconds, the handset will be
off. There will be no Talking keypad and no keypad back-light.
2. Press and h o ld
key for five more seconds, the handset
3. Please wait 5 -30 seconds for a "di-du sound which confirms"
that handset has established handshaking with the base. The
business phone system.
powers up again.
handset is now ready.
CL-65 Amplified dB level (Amplify on):
CL-30 Amplified dB level (Amplify on):
Tone control settings: 4 settings (T1 = lowest tone, T4 = highest tone)
Talking CID / Keypad voice: English or French
Flash time: 600 msec
Dialing: T one or pulse
Dimensions
Handset size: 7.0"x 2.1"x 1.2"
Base size: 6.7"x 3.1"x 5.0"
Weight
Handset weight: 5.7 oz.
Base weight: 16 oz.
Temperature range:
Operating: 0 to 40℃
Storage: -10 to 50℃
Power requirements:
AC Adapter: UL listed 7.5vdc, 300 ma
37 to 55 dB (measured at 3 Khz with Tone=4)
22 to 40 dB (measured at 3 Khz with Tone=4)
Base battery: 4 xA AA size NIMH (optional and are provided by user)
Handset battery: 2 x AAA size NIMH (included)
Trouble Shooting
Q1: Base Charging Indica tor s not on when handset is placed i
Ans: Move the ha n d set slightly to make better contact.
Q2: No CID announcement on a n incoming call.
Ans: Make sure the T a lking CID feature is turned on (check
Switch 2 setting in battery compartment). Check your CID
subscription with your phone company.
on the base.
13 14
Specifications are adjected to change without any notice