TM Mico-Switch/8 8 Port 10/100Base-TX Switch (Auto MDI/MDIX) FEP-32008T-3 USER’S MANUAL
Package Contents Package contents include the following: Micro-Switch/8; 8 Port 10/100Base-TX Switch DC power adapter Four (4) adhesive-backed rubber feet User’s manual Warranty card TM TM Mico-S witch/8 8 Port 10/100Base -TX Switch (Auto MDI/MDIX) FEP-32008T-3 USER’S MANUAL Micro-Switch/8 8 port Switch User’s Guide Rubber feet Power Adapter Figure 1. Contents of package IMPORTANT: If any piece is missing or damaged, please contact your local dealer or reseller for service.
Introduction The 8 port Mico-Switch/8 (Auto MDI/MDIX) is a compact Fast Ethernet switch that provides wire-speed, a Fast Ethernet switching function which allows high-performance, low-cost connections to Full-duplex, Half-duplex 10Mbps and 100Mbps Ethernet networks. The Mico-Switch/8 delivers all the advantages of a switching hub in a compact desktop size and is ideal for small office or SOHO network users. It’s also wall mountable which conserves office space.
Hardware Description The Front Panel The front panel consists of LED Indications. LED Indicators Per Device: Per Port: Power LINK/ACT (Link/Activity) Power Indicator Power Mico-Switch/8 LINK/ACT 8 Port 10/100Base-TX Switch 1 2 3 4 5 6 7 8 LINK/ACT Indicators Figure 2. Front panel view of LED indications LED Status Color Description Power On Green The switch is supplied with suitable power. On Green The port is connecting at 10Mbps.
The Real Panel The rear panel view of the Mico-Switch/8 consists of a DC power connector and 8 auto-sensing ports. 8 7 6 5 4 3 2 1 DC 9V Figure 3. Rear panel view of the Micro-Switch/8 RJ-45 Ports ( Auto MDI/MDIX ) 8 auto-sensing ports of 10/100 N-way for 10Base-T or 100Base-TX connections. [ In general, MDI means connecting to another Hub or Switch while MDIX means connecting to a workstation or PC.
Troubleshooting The Switch can be easily monitored through panel indicators to assist in identifying problems. This section describes common problems you may encounter and possible solutions. Power If the power indicator does not light when the power cord is plugged in, you may have a problem with the power outlet or cord. However, if the power LED goes off after running for a while, check for loose power connections, power losses or surges at the power outlet.
Product Specifications Standard Compliance: IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100Base-TX Fast Ethernet IEEE 802.3x Flow Control Portocol: CSMA/CD Transfer Rate: 14,880 pps for 10Mbps 148,800 pps for 100Mbps Connector: RJ 45 MAC Address: Memory Buffer: 1K Mac address table LED Indicator: Per port: Link/Activity Auto MDIX on all ports 768KBits Per unit: Power Network Cable: 10Base-T: 2-pair UTP Cat. 3,4,5e cable (100m), EIA/TIA-568 100-ohm STP (100m) 100Base-T: 2-pair UTP Cat.
TM 565 Brea Canyon Rd., Ste A Walnut, CA 91789 Phone: 626.964.7873 www.unicomlink.com Fax: 626.964.7880 e-mail: info@unicomlink.com @UNICOM 2007. UNICOM and “A Network Systems Solution” are trademarks of UNICOM Electric, Inc. All rights reserved. Specifications subject to change without notice. Rev: 11.
