User`s manual

ENDAT-2794A USERS MANUAL
UNICORN COMPUTER CORP.
29
˙On-Chip Serial ATA
Disabled Disables the onboard SATA.
Auto
The system will detect the existing SATA and IDE
drives then automatically set them to the available
master/slave mode.
Combined
Mode
This option allows you to use both IDE and SATA
drives; allowing a maximum of 4 drives. You must
manually set the SATA drives’ master/slave mode in
the “Serial ATA Port0 Mode” and “Serial ATA Port1
Mode” fields.
Enhanced
Mode
This option allows you to use both IDE and SATA
drives; allowing a maximum of 6 drives.
SATA Only
This option automatically sets the SATA drives to
Primary Master and Secondary Master modes. Since
both drives are in master mode, you cannot set the
IDE drives to Master mode. The “Serial ATA Port0
Mode” and “Serial ATA Port1 Mode” fields will not be
configurable.
˙SATA PORT Speed Settings
The SATA PORT Speed Settings option controls the maximum access speed
allowed for the connected SATA devices, with the GEN I setting used for
SATA-150 type devices and GEN II used for SATA II type devices.
˙PATA IDE Mode
These fields are used to select the master/slave mode of the serial ATA drives.
Make sure they do not conflict with the settings of the IDE hard drives.
SuperIO Device
Item Available Options:
POWER ON Function BUTTON ONLY
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
ECP Mode Use DMA 3
PWRON After PWR-Fail off