User`s manual
User’s Manual     45 
Appendix B: LCD Pin Assignment 
LVDS1: Dual Channel LVDS (2.54mm) 
Pin No.  Signal  Pin No.  Signal 
1 
VBL (+12V) 
2 
VBL (+12V) 
3 
GND 
4 
GND 
5 
DISP.ON/OFF 
6 
GND 
7 
LVDD 
8 
LVDD 
9 
GND 
10 
GND 
11 
RxO0+ 
12 
RxO0- 
13 
RxO1+ 
14 
RxO1- 
15 
RxO2+ 
16 
RxO2- 
17 
RxO3+ 
18 
RxO3- 
19 
RxOC+ 
20 
RxOC- 
21 
GND 
22 
KEY 
23 
RxE0+ 
24 
RxE0- 
25 
RxE1+ 
26 
RxE1- 
27 
RxE2+ 
28 
RxE2- 
29 
RxE3+ 
30 
RxE3- 
31 
RxEC+ 
32 
RxEC- 
33 
LVDD 
34 
LVDD 
35 
GND 
36 
GND 
37 
GND 
38 
GND 
39 
VBL (+12V) 
40 
VBL (+12V) 
Please make sure the Pin 1 location before inserting the LCD connector. 
BIOS LCD panel type list (Advance Chipset Setup/Panel Type) 
Panel Number 
1024x768 24Bit 1CH 
1280x1024 48Bit 2CH 
1280x768 24Bit 1CH 
1366x768 24Bit 1CH 
46         The ENDAT-9401F/H System Board 
Appendix C: Limited Warranty 
Standard two years limited warranty on all our ENDAT series all-in-one 
motherboards and embedded boards. Products that become defective during the 
warranty period shall be repaired, or subject to manufacturer’s option, replaced.  
The limited warranty applies to normal proper usage of the hardware and does not 
cover products that have been modified or subjected to unusual electrical or 
physical stress. Unicorn Computer Corp is not liable to repair or replace defective 
goods caused by improper using or use of unauthorized parts. The following 
situations will be charged: 
1. The products during the warranty but defective caused by improper using or 
artificial external pressure and result in the components damages. According to 
the damage situation, the manufacturer has the rights to decide to repair or not. 
The manufacturer will charge the parts/repair cost and the returning shipping 
charge. 
2. The products out of warranty will charge the parts/repair cost and the returning 
shipping charge as per the repair status. 
3. The manufacturer has the rights to decide to repair or not based on the stock of 
parts for the products which are phased out of the production. 
4. Please e-mail or fax the RMA Service Request Form when have the defective 
products. 










