User's Manual

- 9 -
KEY PRESS TO... PRESS AND HOLD TO ...
Delete Mute Memory - Press MUTE/
DIM while Mute Memory displays; the R9
Extreme displays a delete confirmation
message. Press MUTE/DIM again to
confirm.
MUTE RED LIGHT CAMERA VOICE ALERTS
Mute the voice alert for a red light camera
alarm. Press MUTE/DIM while the voice
alarm for a red light camera sounds. The
voice alarm mutes.
MUTE ALERTS FOR POI OVERSPEED ALERT
AND USER LIMIT SPEED
When R9 Extreme alerts you to an
overspeed or speed limit situation (an
alarm sounds and an alert displays), press
MUTE/DIM to silence that alarm.
DELETE RED-LIGHT
CAMERA POINT
During a red-light camera
alert, press and hold
MUTE/DIM to delete the
red light camera point.
A confirmation message
displays.
After confirming this
deletion, R9 Extreme will
not give an alert for that
camera.
MARK User Mark. A User Mark is a manually
tagged geographic location where an
alarm is usually found. The R9 Extreme
alerts when close to these User Marks.
Add - Press MARK when you are at the
alarm location.
Delete - Press MARK when you are at an
alarm location that has been marked.
An error message displays/sounds if
memory is full or there is a GPS error.
Delete all User Marks
(press and hold for 3
seconds).
DISPLAY UNIT
The separate display unit installed in the dashboard is the visual display for alarms,
alerts, and menu selections. It also displays from which direction the signals are
coming.
If GPS = ON, the OLED’s left display area shows the display selected in the menus
(see page 19).
If GPS = Off, the OLED’s left display area shows Volt regardless of user settings.