User's Manual

talkgroup is not active, change the Scan List by using the

Menu screen.

Note: • Once you press SEARCH or SERVICE in one bank,

all trunking banks will change to that mode.

• Selecting a Scan List is also possible in the Menu

mode. (LTR only)

• ID SCAN appears on the display during Trunk

Scan instead of simply SCAN.

Setting the Delay Mode for Trunking Mode

The delay of 5 seconds is automatically set for each talkgroup

for ID Scan mode and ID Search mode. To set the delay

feature, enter into the Menu mode.

1. Press MENU/BACK.

2. Select SCAN OPTION-TRUNK by rotating the VFO and

pressing E.

3. Select the bank number by rotating the VFO and pressing

4. Select DELAY and then press E.

5. Rotate the VFO to select ON or OFF and then press E.

Note: If you want to verify Delay mode setting, press and

hold MENU/BACK for 2 seconds.

Setting Priority in Trunking Mode

You can set priority in your trunking lists, just as you do in

your conventional ones. You can set the priority by pressing

and holding PRI for 2 seconds in ID Scan Hold mode.

After you’ve set up your Scan List, press PRI to activate it.

It’s very similar to conventional priority although there is no

"interrupt" during the transmissions. Priorities are checked in

between transmissions.

With Priority On, you can hold on an ID in your Scan List,

such as Scan List 6, memory position 7, and the scanner will

check all the priorities in all the active Scan Lists in between

any transmissions on the ID on which you’re holding. The

lowest numbered priority will be checked first. For example,

the priority ID in List 1 will be checked before the priority in

List 2, etc.

Note: This function does not work in LTR tracking.

BC250D 9/20/2 2:52 PM Page 58