User's Manual
The scanner searches only one range at a time.
Holding On An Active Frequency
To hold on the current frequency, press
HOLD
U
.To resume
searching, press
SRC
.
Setting Chain Search
The scanner allows you to search multiple conventional frequency
ranges simultaneously. The scanner searches only one range at a
time.
Note: You cannot use chain search to search trunked frequencies.
You can search trunked frequencies using the scanner’s ID search
mode.
1.
Press
SRC
.
2.
Press
HOLD
U
or rotate the rotary tuner to go to search hold
mode.
3.
Press the bank keys where you want to search for
frequencies. The selected range and the lower and upper limit
frequencies for the range you selected appear.
4.
Use the keypad to enter the lower and upper frequency limits,
then press
E
.
5.
Press
SRC
to start chain search.
Setting Data Skip
The scanner normally stops on any frequency with activity, and
remains there until either the activity stops or you press
SRC
to
resume scanning. However, some signals are identifiable by the
scanner as data signals, and you can set the scanner to
automatically skip these channels.
Note: Even with this option turned on, the scanner might pause for
a couple of seconds on data transmissions before resuming.
Skipping Frequencies
If a particular frequency continues to interrupt search scanning, you
can set the scanner so it skips the frequency.
To skip over a frequency, press
L/O
when the scanner is stopped
on a frequency you want to skip.
Notes:
70/305ページCONTENTS
2004/04/01file://¥¥Fileserv0¥OM¥UB322ZBC898¥Software%20Help.htm