User's Manual

5.
Press
MANUAL
or
HOLD
U
to stop auto store. The scanner
exits the auto store mode.
Note: To ensure that you catch most active frequencies for
the band, you should allow the auto store operation to
continue through at least a few complete sweeps of the
band. Depending on the types of services, some
occasionally active frequencies might not have activity for
minutes or hours at a time.
Setting Subaudible Tones for Searching
You can set the scanner to only stop on transmissions that either
have no subaudible tone or include a specified CTCSS or DCS tone
during searches. This setting affects all search ranges. For this
feature to work, you need to turn on the tone mode (see Setting the
Squelch).
1.
Press
PRI
to turn off priority scan.
2.
Hold down
CTCSS/DCS
for about 2 seconds.
CTCSS
and
DCS
blink and the scanner searches for CTCSS or DCS
tones. When the scanner finds a CTCSS or DCS tone, the
frequency blinks.
Attenuating All Search Ranges
If you are near a strong RF source, you might need to attenuate the
input signal in order to search properly. Repeatedly press
ATT
until
A
T
T
appears (to turn on attenuation) or until
ATT
disappears (to
turn off attenuation).
Setting Delay For All Search Ranges
You can set the scanner to have a 2-second delay after the end of
a transmission before searching resumes. This slows searching,
but helps you prevent missing replies on a frequency. To turn on
this option for all search ranges, select the channel where you want
to add a delay then press
DELAY
.
Searching a Trunked Bank
Before you search a trunked bank with your scanner, consider the
following:
z You can only trunk track one bank at a time.
z Use
TRUNK
to toggle between the conventional and the trunk
tracking modes.
z
Press
DATA
while in the trunk tracking mode to review which
bank is currently in use. The appropriate bank icon will flash
72/305ページCONTENTS
2004/04/01file://¥¥Fileserv0¥OM¥UB322ZBC898¥Software%20Help.htm