User's Manual
•
NOAA broadcasts are continuous broadcasts. You will only
lose reception if you move out of a coverage area. If the
signal is lost, the scanner resumes searching for a weather
transmission.
Programming a FIPS Code
1.
Hold down
WX
to turn on weather alert.
2.
Hold down
E
.
If the scanner has not been set to alert for any FIPS code,
____
appears. If the scanner is set to alert for all FIPS
codes,
ALLFIPS
appears. If the scanner is set to alert only
for the area you programmed,
F1
appears.
3.
Turn the rotary tuner or repeatedly press
HOLD
U
or
LIMIT
V
to enter a FIPS code (1 through 15). Then press
E
to
enter the FIPS code or
.
to clear it.
4.
To set the scanner so it sounds an alert tone when it
receives any FIPS code, turn the rotary tuner or repeatedly
press
HOLD
U
or
LIMIT
V
to move
ALLFIPS
to
F1
. To set
the scanner so it sounds an alert tone when it receives only
the FIPS code you programmed, turn the rotary tuner or
repeatedly press
HOLD
U
or
LIMIT
V
to move
F1
to
F15
.
Then press
E
.
5.
Press
ALERT
to exit this mode.
Search Hold
1.
Press
HOLD
U
at any time to stop the search.
2.
Press
HOLD
U
to move to the next higher frequency
— or —
3.
Press
LIMIT
V
to move down to the previous frequency.
Note: You can also use the rotary tuner to move to other
frequencies. Simply make sure the FREQ LED is lit before
turning the dial.
4.
Press
SRC
to resume searching.
Searching for CTCSS/DCS Tones
You can use the CTCSS/DCS tone search mode to determine if the
frequencies in your area are transmitted with associated tones. If
75/305ページCONTENTS
2004/04/01file://¥¥Fileserv0¥OM¥UB322ZBC898¥Software%20Help.htm