User's Manual

a. Repeatedly press
HOLD
U
or
LIMIT
V
until
Prog id
appears. Then press
E
.
b. To enter a Type 2 ID, use the keypad to enter it. Then
press
E
. Otherwise, to enter a Type 1 ID, use the keypad
to enter the fleet map information you entered or selected
in Step 6. Then press
E
.
Programming EDACS Systems
1.
Hold down
TRUNK
for about 2 seconds. The scanner beeps and
TRUNK
,
BANK
, and
the bank letters A-J blink.
2.
Select the bank by entering the letter for the bank. This bank is where the frequencies
you enter will be stored.
3.
Select EDACS scanning by turning the rotary tuner or
repeatedly pressing
HOLD
U
or
LIMIT
V
to select one of the
following EDACS scanning options:
z
Ed-Hi
(Wideband, 9600 bps)
z
Ed-Lo
(Narrowband, 4800 bps)
z
Ed-SCt
(SCAT)
Then press
E
.
4.
Enter the talk group ID (agency, fleet, and subfleet) for the system you want to scan,
then press
E
.
If the system uses multiple talk group IDs, repeat Step 4.
5.
Use the keypad to enter the frequency for LCN1, then press
E
.
Note: To clear a mistake while entering a frequency, press
.
(decimal) on the keypad
twice, then repeat Step 5.
6.
Repeat Step 5 for each frequency. When you enter a
frequency, select the next channel by turning the rotary tuner
or repeatedly pressing
HOLD
U
or
LIMIT
V
to select the next
channel in the bank. Then press
E
Programming LTR Systems
1.
Hold down
TRUNK
for about 2 seconds. The scanner beeps and
TRUNK
,
BANK
, and
the bank letters A-J blink.
2.
Select the bank by entering the letter for the bank.
3.
Select LTR scanning by turning the rotary tuner or repeatedly pressing
HOLD
U
or
LIMIT
V
to select
Lt
. Then press
E
.
92/305ページCONTENTS
2004/04/01file://¥¥Fileserv0¥OM¥UB322ZBC898¥Software%20Help.htm