User's Manual

Using the C lo se C a ll Fe a ture

Setting the Close Call Mode

1. Press then turn the scroll control until Close

Call appears. Then press . One of the Close Call

feature options appear.

2. Turn the scroll control until one of the following Close

Call feature options appears.

• Cl ose Cal l Onl y : Lets you set the scanner only for

Close Call searching. The scanner does not scan fre-

quencies or channels when this option is turned on.

To select this option, press . The scanner searches

in Close Call mode.

• Set CC Bands: Lets you select the Close Call band

settings. You can turn the following bands on or off.

VHF Low (25.0000 - 54.0000 MHz)

Air Band (108.0000 - 136.9750 MHz)

VHF High (137.0000 - 224.9950 MHz)

UHF (400.0000 - 512.0000 MHz)

800M Hz+ (806.0000 -1300.0000 MHz)

Turn the scroll control to select a band, then press to

turn it on or off.

• Set CC Al er t : Lets you select how the scanner alerts

yu when it receives a Close Call signal. You can

select any of the following options.

Beep+Light (the scanner beeps and the display backlight

turns on when it receives a Close Call signal)

Light (the display backlight turns on when it receives a

Close Call signal)

Beep (the scanner beeps when it receives a Close Call

signal)

None (the scanner does not beep and the display back-

light does not turn on when it receives a Close Call signal)