User's Manual

Turning Re pe a te r Find O n o r O ff

Turning Repeater Find On or Off

You can set the scanner so it attempts to locate

transmissions on repeater output frequencies when it

detects a transmission on a repeater input frequency.

If the scanner finds such a transmission, it beeps and

Repeat er Out put Found appears on the display, and it

tunes the output frequency. If it does not detect the

transmission on the output frequency, it remains on the

transmission on the original frequency.

1. Press then turn the scroll control until Sr ch/

Cl oCal l Opt appears. Then press . One of the

Close Call options appear.s

2. Turn the scroll control until Repeat er Find appears.

Then press . One of the following options appears.

On (the scanner attempts to locate transmissions on

repeater output frequencies when it detects a transmis-

sion on a repeater input frequency))

Off (the scanner does not attempt to locate transmissions

on repeater output frequencies)

3. Turn the scroll control to display the option, then

press to select it.

• You might find frequencies that do not have a tone

associated with them. This might be because CTCSS

or DCS tones are not being transmitted.

1. If necessary, press PRI to turn off priority scan.

2. Hold down CTCSS/DCS until you hear two short

beeps.

CTCSS and DCS appear and begin to flash. If

there is a break before a tone is identified, your scan-

ner searches where it left off when the transmission

begins again.

Turning Repeater Find On or Off