User's Manual

82
C a re a nd Ma inte na nc e
Care and Maintenance
General Use
• Turn the scanner off before disconnecting the power.
• Always write down the programmed frequencies in
the event of memory loss.
• If memory is lost, simply reprogram each channel.
The display shows 000.0000 in all channels when
there has been a memory loss.
• Always press each button firmly until you hear the
entry tone for that key entry.
Location
• Do not use the scanner in high-moisture environ-
ments such as the kitchen or bathroom.
• Avoid placing the unit in direct sunlight or near heat-
ing elements or vents.
• If the scanner receives strong interference or electri-
cal noise, move it or its antenna away from the source
of the noise. If possible, a higher elevation might pro-
vide better reception.
• Also try changing the height or angle of the antenna.
Cleaning
• Disconnect the power to the unit before cleaning.
• Clean the outside of the scanner with a mild deter-
gent.
• To prevent scratches, do not use abrasive cleaners or
solvents. Be careful not to rub the LCD window.
• Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no user
serviceable parts. Contact the Uniden Customer Service
Center or take it to a qualified repair technician.
Care and Maintenance