User's Manual

Before the scanner begins Private Bank scanning, you must program a frequency
into at
least one channel. Program frequencies you purchased from your dealer, from
various free
and FCC-based sources on the internet, or from the Frequency guide included in
20-426
package. You will need to program each frequency into the
scanner’s channels in order to hear these frequencies.
1. While Private Bank scanning is activated, press
HOLD/RESUME and enter the channel number where you
want to store a frequency by using the keypad, then press
HOLD/RESUME.
✎ Change the channel by using the ▲ or ▼ key.
2. Enter the frequency you want to store by using the keypad
and (decimal key).
3. Press E to store the frequency into the channel.
4. If you want to program another frequencies into the channel,
select another channel by using the ▲ or ▼ key.
Note: • To clear a mistake while entering the frequency, press (decimal key)
repeatedly until the display is cleared.
• If you enter a invalid frequency, an error tone will sound and appears on the
display. To clear the Error message immediately, press (decimal key).
• Even if you don't enter full numbers as a frequency number, the scanner will
automatically
select the nearest valid frequency.
Deleting a Stored Frequency
To delete a stored frequency:
a. Select a channel.
b. Press 0.
c. Then press E.
Note: Channels with no frequencies are automatically locked out.
.
.
.
20-426 8/22/03 1:40 PM Page 21
22
Duplicate Frequency Alert
If you enter a frequency which has been stored in another channel, you will hear an
error
tone and the other channel displays.
Press (decimal key) to clear and start again.
––– OR –––
Press E again to store the frequency in both channels.