User's Manual

mode, you
never need to worry about missing these transmissions. If you have
programmed talkgroup
33264 into Scan List memory, for example, and there is an emergency call
within the group,
you will hear it on 33264.
The only time you may wish to turn Status Bits OFF is if you're trying to figure
out the proper
Fleet Map of a Type I trunking system.
1. Press and hold TRUNK for 1.5 seconds and select the bank you want to
change.
2. Use the ▲ or ▼ key to select (Motorola TYPE2 800MHz), (Motorola Type2
VHF) or (Motorola Type2 UHF), then press E.
3. Use the ▲ or ▼ key to select , then press E.
4. Use the ▲ or ▼ key to select or , then press E. The scanner returns to
Status Bit list item.
Control Channel Only Mode
When this function is activated, trunking is performed using Control Channel
data only.
Voice channel (also known as "DATA channel") frequencies do not have to be
programmed
into memory. This feature only applies to Motorola 800 MHz systems.
1. Press and hold TRUNK for 1.5 seconds and select the bank you want to
change.
2. Use the ▲ or ▼ key to select (Motorola Type2 800MHz) or (Motorola Type1
800 MHz), then press E.
3. Use the ▲ or ▼ key to select , then press E.
4. Use the ▲ or ▼ key to select a plan from 4 frequency plans,
then press E. The scanner returns to Control Channel Only
list item.
Note: You must choose a plan before you begin to Control Channel Trunk (Only
when 800
MHz system is selected).
When you deselect Control Channel only mode, appears on the display.
Read the descriptions of the Plan 1~4 for details on which may apply for you.
PL1 (plan 1): This plan is the most common. Use Plan 1 if the last three digits of
ALL the
frequencies in use end in one of the following three digits: 125, 375, 625, or 875
(example:
856.1125, 860.7375, 859.6625, 855.8875).