User's Manual

transfer. This one
must be set up as the "First Unit", and the other must be set as the "Clone
Unit".
3. On the scanner that is the "Clone Unit", use the ▲ or ▼ key
to select , then press HOLD/RESUME.
4. On the scanner that is the "First Unit", use the ▲ or ▼ key to
select , then press HOLD/RESUME.
Care and Maintenance
General Use
. Turn the scanner OFF before disconnecting the power.
. Always write down the programmed frequencies in the event of memory loss.
. If memory is lost, simply reprogram each channel.
The display shows 000.0000 in all channels when there has been a memory loss.
Location
. Do not use the scanner in high-moisture environments such as the kitchen or
bathroom.
. Avoid placing the unit in direct sunlight or near heating elements or vents.
. If the scanner receives strong interference or electrical noise, move it or its
antenna away
from the source of the noise. If possible, a higher elevation may provide better
reception.
Cleaning
. Disconnect the power to the unit before cleaning.
. Clean the outside of the scanner with a mild detergent.
To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to
rub the
LCD window.
. Do not use excessive amounts of water.
Repairs
. Do not attempt any repair. The scanner contains no user serviceable parts.
Contact the
Radio Shack Customer Service Center or take it to a qualified repair technician.
Birdies
. All radios can receive birdies (undesired signals). If your scanner stops during
Scan mode
and no sound is heard, it may be receiving a birdie. Birdies are internally
generated
signals inherent in the electronics of the receiver.
Press L/O to lockout the channel, and then press HOLD/RESUME to resume