User's Manual

You See Trunk System
E1 Motorola Type I, and Hybrid
Ed EDACS Wide Band: 9600 baund
E2 – 800 Motorola Type II, 800 MHz frequencies
E2 – 900 Motorola Type II, 900 MHz frequencies
E2 – Hi Motorola Type II, VHF(136-174 MHz) frequencies
E2 – UHF Motorola Type II, UHF (400-512 MHz) frequencies
Ed – SCt EDACS Scat
Lt LTR
3. PROG F appears, then press E/PGM. The scanner automatically selects the first
channel in the selected banks.
4. Use the number keys to enter a valid frequency within the trunk system, then press E/PGM.
The bank number, the channel number, and E (EDACS) ,M (Motorola) or L (LTR) appears
depending upon the trunk system selected.
Notes:
• If you enter an invalid frequency (outside the selected range), the scanner beeps, the channel number
flashes and Error appears. If this happens, press
・/CLR /DELAY to clear the frequency, then repeat
the entry.
• For EDACS and LTR systems, you must enter the frequencies in logical channel number (LCN) order.
• If you try to enter a duplicate frequency in a bank, the scanner beeps and the channel which was
previously stored appears.
5. Press
or to select the next channel in the bank.
6. Repeatedly press
・/CLR /DELAY to return back to Step 2. Repeat Steps 2 and 5 until all frequencies have
been entered.
7. Press SRCH to begin searching for the trunk’s data channel and scan conventional frequencies at the
same time.
As the scanner looks through the frequencies, you see them on the display.
When the scanner finds the controlling data channel, the scanner begins trunking.
SEARCHING A TRUNKED BANK
Once the data channel is acquired, the scanner begins a trunk search.
With the search function, you will be able to find all the active talk groups within the trunked system.
Press SCAN/MANUAL. You can switch to the trunk scan mode from the trunk search mode.
See “Scanning the Talk Group ID Lists” on Page XX.
While scanning conventional frequencies, follow the steps below to switch to the trunk mode
after the scanner finds the data channel.
1. Press TRUNK. The scanner begins scanning both trunking and conventional banks.
2. Hold down TRUNK for about 1 second. The scanner switches to the trunk scan mode.
3. Hold down TRUNK for about 1 second again. The scanner switches to the trunk search mode.