User's Manual

6. Press the number keys to enter a new base frequency, then press E/PGM.
7. press
. The display changes to the spacing frequency entering mode.
8. Enter the frequency using the number keys according to the following guide, Then press E/PGM.
• For Motorola Type II VHF, (E2-VHF Hi band) use 5kHz steps between 5 kHz – 100 kHz.
• For Motorola Type II UHF, (E2-UHF band) use 12.5kHz steps between 12.5 kHz – 100 kHz.
9. Press
. The display changes to the offset channel entering mode.
10. Enter a offset channel using the number keys, then press E/PGM.
Note: Your can only input the frequency between 380 – 759.
11. Press
・/CLR /DELAY. The scanner returns to previous screen. Repeat the step 5 to 10 if you want to
program other configuration.
Programming a Hybrid System
A hybrid system is simply a Type I system with some of its blocks designated as Type II blocks.
To program a hybrid system, follow the steps listed in “Programming a Fleet Map” on Page XX.
However, if you want a block to be Type II, instead of pressing
or to select the
size block (Step 7), enter size code S-0 instead.
Turning On/Off the Motorola Disconnect Tone Detect Function
When this function is disabled, the radio looks for squelch before returning to the control channel
instead of waiting for the disconnect tone. Only in rare instances will you need to adjust the default settings. The
condition to return to control channels depends on whether the signal is present or not.
1. Select the trunking programming mode and the bank you want to change.
2. Press
or to select Motorola Type 2 or Motorola Type 1, then press E/PGM.
3. Press
or to select Eot, then press E/PGM.
4. Press
or to select Eot ON or Eot OFF, then press E/PGM.
Note: If you set the squelch so you hear a hissing sound, the scanner will remain on the voice channel,
even when a disconnect tone is transmitted or there is no signal at all.
Troubleshooting