Owner's Manual

Setting up the Phone
[11] Setting up the Phone www.uniden.com
Connect the base unit and charge the handset
1) Connect the AC adapter to the DC IN 9V
jack and to a standard 120V AC wall
outlet.
Connect the AC adapter to a continuous
power supply (i.e., an outlet that is not
controlled by a switch).
Place the base unit close to the AC
outlet to avoid long extension cords.
2) Place the handset in the base unit with
the top panel facing forward.
Place the base unit close to the AC outlet to avoid long extension cords.
3) Make sure that the charge LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
4) Charge your handset at least 10 hours before plugging into the phone line.
5) Once the handset battery pack is fully
charged, connect the telephone line
cords to the TEL LINE jack and to a
telephone outlets.
• Use only the supplied
AD-800 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
•Don't place the base in
direct sunlight or
subject it to high
temperatures. The
battery may not charge
properly.
for assistance.
If your telephone
outlet isn't modular,
contact your
telephone company.
note
UP742.book Page 11 Tuesday, November 30, 2004 2:42 PM