User manual

Setting Up Your Scanner

• To prevent damage to Ni-MH batteries, never

charge them in an area where the temperature is

above 113°F (45°C) or below 40°F (4°C).

• If you connect an external power source to the

scanner with REG. ALK. BATT./NI-MH BATT.

set to REG. ALK. BATT., the scanner does NOT

charge the batteries. Make sure that you use the

correct batteries and set REG. ALK. BATT./

NI-MH BATT. to the correct position when you

connect an external power source.

Using AC Power

You can power the scanner using the supplied 6V,

500 mA AC adapter.

To use the scanner on AC power, plug the AC adapter

into DC 6V on the side of the scanner then plug the

other end into a standard AC outlet.

If rechargeable batteries are installed without

removing the sticker, or, after removing,

REG. ALK. BATT./NI-MH BATT. is set to NI-MH BATT.,

the adapter powers the scanner and recharges the

installed batteries at the same time.

UB340ZH Paper OM reduced size.fm Page 19 Monday, September 26, 2005 2:56 PM