User manual

42
Special Features
If you enter a frequency that is out of range, the
scanner sounds an error tone and Error appears.
Press Func + 8/ to change the search direction
downward or Func + 2/ to change the search
direction upward. Frequencies appear during the
search.
Notes:
• You can set the delay function on or off during
the search or while the search stops.
• You can skip a frequency when the search stops.
After the search skip frequency is set, the scan-
ner starts direct search again.
Direct Entry Search Hold Mode
To stop searching during direct entry search, press Hold/
. Hold appears. In this mode, pressing Func +
8/ changes the search direction downward and
pressing Func + 2/ changes the search direction
upward. or appears depending on the search
direction.
Press Func + 8/ to decrease the frequency by
one step or Func + 2/ to increase it by one step.
Hold down 2/ or 8/ for about 1 second to quickly
increase or decrease the frequency.
To resume direct search, press Func + Scan/Src or
Hold/ . or appears on the display, showing
the search direction.
Storing Frequencies Found During Direct
Entry Search into Channel Memory
Follow these steps to store frequencies received
during direct entry search mode or direct entry
search hold mode.
UB340ZH Paper OM reduced size.fm Page 42 Monday, September 26, 2005 2:56 PM